Service Center
FT5002HART Transmitter Receiver
》》》》 Specifications
Ø Power：use standard 85-265VAC power supply，power rating 10W
Ø Input signal：single 4～20mA & standard HART protocol （No verification below HART6.0version short frame address，instrument support 1-2 equipment variables’ display/control）
Ø Digital Indication：Dual channel 5 LED digital tube display
Ø Bar-graph Indication：Dual channel 101 bit LED display
Ø Alarm Indication：Dual channel high /low LED display（linkage with corresponding relays）
Ø Output signal：Isolated two channel 4～20mA, built-in power supply，load resistance 600Ω
Ø Output control signal：Dual relay SPDT outputs in each channel; contact rating: 250VAC：1A inductive，3A non-inductive
Ø Basic error： Digital display：± 1 digit; Bar-graph display：±1line ; specification error：± 1 digit switching error：± 1 digit
Ø Output accuracy：0.1% of current output accuracy
Ø Adjustable alarm setting in dual channel
Ø Adjustable alarm hysteresis error
Ø Current output in dual channel could be recalibrated, also with short circuit protection
Ø Adjustable zero shifting setting in dual channel
Ø Built in 24VDC power supply for field instrument with current limiting、three-limiting voltage with short circuit protection
Ø Process temp.： 0℃～+70℃
Ø Process humidity：relative humidity：5%～90%
Ø Installation：panel mounting，160X80mm vertical; hole size: 152X72mm; dimension：（height ×width ×depth）：160×80×90mm
Ø EMC：meet IEC61326：1997+A1：1998 standard requirements